Each cable consists of:
- 4mm 7x7 Stainless steel rope
- Two back mounting sockets (either full sockets or C sockets)
- One swage ball
- One threaded ball
- One swage adjuster with lock nut
Wires are supplied swaged to the appropriate terminals. The swage end (with the threaded ball supplied loose) can be fed through intermediate posts with a clearance hole of at least 7mm. Once the cable has been slotted through the final intermediate post the ball can be screwed back on. Tension is achieved rotating the threaded ball on the adjuster end using the spanners flats, then locking with the lock nut.
There is an adjustment of 20mm+/- on each swaged assembly.
Remember - measure twice, cut once! Please be as accurate as possible. Each cable will have an adjustment of plus or minus 20mm.
To specify the required length of balustrade assemblies, measure the distance between the OUTSIDE FACES of the posts in millimetres.
